• 목록
• 답변
• 글쓰기
• 게시판 리스트 옵션
  • 수정
  • 삭제

A fluorescent lamp is crammed with a gasoline containing low strain mercury vapor and argon (or xenon), or more rarely argon-neon, or generally even krypton. The efficiency of fluorescent lighting owes much to the truth that low strain mercury discharges emit about 65 p.c of their complete mild at the 254 nanometer line (also about 10-20 p.c of the sunshine emitted in UV is on the 185 nanometer line). The mercury, which exists at a stable vapour pressure equilibrium level of about one half per thousand in the inside of the tube (with the noble fuel strain typically being about 0.3 percent of customary atmospheric stress), is then likewise ionized, causing it to emit gentle in the ultraviolet (UV) region of the spectrum predominantly at wavelengths of 253.7 nanometers and 185 nanometers.

This increased vitality state is unstable, and the atom will emit an ultraviolet photon as the atom's electron reverts to a lower, extra stable, vitality stage. This fluorescent conversion occurs within the phosphor coating on the internal surface of the fluorescent tube, where the ultraviolet photons are absorbed by electrons within the phosphor's atoms, causing a similar vitality leap, then drop, https://www.vapingquick.com/milky-mandrill-by-wicked-monkeys-100ml-e-liquid-70vg-vape-0mg-juice with emission of a further photon. When all the emission mix is gone, http://https%253a%252F%25evolv.e.l.U.Pc@haedongacademy.org/phpinfo.php?a%5B%5D=%3Ca+href%3Dhttps%3A%2F%2Fwww.vapegot.com%2Fcola-lime-pod-salt-fusion-20mg-10ml%3Ehttps%3A%2F%2Fwww.vapegot.com%2Fcola-lime-pod-salt-fusion-20mg-10ml%3C%2Fa%3E%3Cmeta+http-equiv%3Drefresh+content%3D0%3Burl%3Dhttps%3A%2F%2Fwww.vapegot.com%2Fvoopoo-uforce-n1-coils+%2F%3E the cathode cannot go adequate electrons into the fuel fill to take care of the discharge on the designed tube working voltage.

When the tube lights, the voltage and frequency throughout the tube and capacitor typically each drop, thus capacitor current falls to a low but non-zero worth. Begin low and https://www.vapegot.com/cola-lime-pod-salt-fusion-20mg-10ml go sluggish to seek out your minimal effective dose. Better high quality fluorescent lamps use both a better-CRI halophosphate coating, or https://www.vapingquick.com/jam-on-toast-by-signature-10-x-10ml-e-liquid-50vg-vape-361218mg-juice a triphosphor mixture, primarily based on europium and terbium ions, which have emission bands more evenly distributed over the spectrum of seen mild.

High-CRI halophosphate and triphosphor tubes give a more natural color reproduction to the human eye. At decrease illumination levels, the human eye perceives lower color temperatures as regular and natural. This effect depends upon the tube phosphor, and solely applies to the upper CCT tubes at well under natural daylight levels. Chemicals corresponding to boron (p-type) are applied into the semiconductor crystal so as to create donor and acceptor energy ranges considerably nearer to the valence and conductor https://www.vapingquick.com/orange-lemon-drink-by-yeti-100ml-e-liquid-juice-70vg-vape-shortfill bands.

The photon that is emitted from this second interaction has a decrease energy than the one that brought about it. These electrons collide with and ionize noble fuel atoms in the bulb surrounding the filament to type a plasma by a technique of affect ionization. The main precept of fluorescent tube operation is based round inelastic scattering of electrons. Mains frequency flicker can also sometimes be emitted from the very ends of the tubes, https://www.vapegot.com/crown-v-replacement-coils in consequence of every tube electrode alternately operating as an anode and cathode every half mains cycle, and https://avangardha.com/ producing slightly different light output pattern in anode or cathode mode (this was a more severe challenge with tubes over forty years in the past, and plenty of fittings of that era shielded the tube ends from view in consequence).