• 목록
• 답변
• 글쓰기
• 게시판 리스트 옵션
  • 수정
  • 삭제

Fiat 500 Key Fob Replacement

If your 500 keyfob stops functioning, try another to determine if it will be detected by your car. If it does, the issue may be related to the battery or water damage on the original fob.

First, replace the battery. Make sure that the new CR2032 coin cell battery is inserted correctly, with the "+" side facing down in the fob.

Dead Battery

Most of the time when a fob's not working, it's because the battery is dead. It's a simple fix and the majority of fobs will provide a warning signal if the battery is in low. You can find the instructions on YouTube for nearly every key fob for your car, or in the owner's manual. You can also replace it by taking it to a locksmith or dealer who gave it to you.

Sometimes a fob stops working due to a problem in the internal circuit board. It's not common however it can occur. If you dropped the fob onto something hard, cheapest it could cause damage to the internal chip. It could also happen if you are using an aftermarket fob and the key doesn't work. In this case it is essential to go to a dealer or locksmith to have the key reset so that it works with your 500.

One 2012 FIAT 500 Flip Key Remote - resembles Ilco brand with trunk, lock and lock buttons. It is a replacement fiat 500 key keyless entry remote (will need to be cut & programmed by a locksmith)

Chips that are damaged

A key fob from Fiat 500 is an electronic device that transmits the signal for the car to start once you press the button. It is equipped with a microchip that contains the information which is required to communicate with the car. If the chip is damaged, it won't transmit the correct code and the car won't start. It is possible to repair this kind of damage and a locksmith can help. United Locksmith is capable of completing this service for classic models as well, as for newer models, so don't be in a rush to call them.

You can purchase a new fob and have it programmed professionally by locksmiths. This is less expensive than going to a dealer and will work exactly the same way. You'll need certain information to the locksmith, such as the year your vehicle was built and the model.

Rub the chip with an old dollar bill if not certain what to do. The copper in the bill is abrasive, and can remove oxidation and dirt. However, it won't cause harm to the microchip. If the chip is physically damaged it might not be capable of being repaired. This could happen if fall it, ram it over by accident with your vehicle or other form of physical strain.

Water Damage

Water damage is likely to occur on your fob, no matter if you dropped them in the pool accidentally, left them in a pocket while swimming or splashed water on them during a rainy afternoon. Even if there's only the smallest amount of water on the key, it could cause serious problems with its electronic components.

The good news is that you can solve this issue by taking off the fob's key and using a an old towel to scrub it of any remaining dirt or water. Once the fob is dry and clean, you can replace the battery and it will begin working again.

You can also take your key fob to a local locksmith or auto shop to have it professionally cleaned and programmed. These professionals are able to utilize special equipment to make sure that the key fob works with the car's computer system.

If your Fiat 500's key fob fails to function, it can be stressful and frustrating. It can be costly and cumbersome to take your key fob to the dealer. A locksmith can handle every aspect of your car's key fob replacement without the necessity of a dealership visit. They are a better choice than a dealer since they can handle every aspect of the replacement of your car's key fob without the need for a dealer visit.

Pairing Issues

If you lose your keyfob or it stops functioning and nothing else appears to be wrong, it may be the chip. This could be due water damage, a dead battery or it could just be that you need to reprogramme it.

Most of the time, this can be done by following the directions in your owner's guide. However it's best to have a locksmith from your automotive take care of this if you're having difficulties or the steps in your manual don't work for you. This ensures the chip isn't damaged and is the cheapest solution.

A few hundred owners have reported that their keys will not lock their cars. This could be a problem when you want to fill up at an gas station. Some owners have complained that their 500's locking system has failed and they had to replace the entire intermediate steering shaft. Fiat has even mentioned this problem in a technical bulletin (TSB).

A reputable locksmith is able to assist you should your Fiat is having problems. They'll be able to duplicate your key, or create a new one that will lock and start the vehicle. They can do this without seeing your old key, and is usually cheaper than buying one from a dealer.