• 목록
• 답변
• 글쓰기
• 게시판 리스트 옵션
  • 수정
  • 삭제

Fiat 500 Replacement Key Fob

It's possible to change the battery if your 500 remote key fob isn't working. If you replace the battery and it doesn't work it could be a problem somewhere else.

United Locksmith specializes in the production of new keys for classic cars. We have the tools and components required for this service.

Dead Coin Battery

The most frequent reason that your fiat 500 locked keys in car 500 key fob will not unlock or lock the doors is a dead battery. The battery for the coin cell in the key fob will drain quickly in the event that you don't use it frequently enough. If your remote started to show signs of weakening such as a loss in range, and then stopped working completely, the battery is probably dead.

The battery in the key fob is held in place by steel retaining clips. If the clips are loose, it can cause contact issues that will stop the remote from receiving power. With a small flathead screwdriver, push the retaining clip open to remove the battery and replace it with a new one. Choose a battery that is the same voltage, size, and specifications as the original.

Water exposure can also cause the key fob to become corroded or damaged. Even a quick bath in warm, soapy water could damage the chip. Make sure your key fob is dry.

Water Damage

Water damage may be the reason for your key fob not working properly. Key fobs have rubber seals that protect them from being damaged by light rain or splashes of water. However, it is vital to keep your car keys out of the pool, ocean and the washing machine!

The key fob comes with an electronic chip in it that sends a signal car key cover fiat 500's immobilizer system. The chip allows the 500 to lock and start. If it gets wet, it will no longer function.

Try cleaning the inside of your key fob's electronics with isopropyl alcohol or an electronic cleaner to see if they are still good. However, workshop it is probably better to purchase a replacement from a dealer rather than trying to fix the key fob which is submerged in salt water.

A replacement fob might cost you a little bit but it's far cheaper than having to have your Fiat 500 towed to a dealer and repaired there! In addition, you can do it yourself with only a few steps. Be sure to use the correct type of battery before you attempt to open your key fob. You can find step-by-step instructions for every car keyfob online.

Faulty Chip

The chip that is contained in the key fob communicates with your car's immobiliser unit to make sure your car is only able to start when the correct key is used. If the chip is damaged or destroyed, your car won't start regardless of what you do.

Water damage or a dead phone battery are among the most common causes of a faulty chip. It is best to hand over the work to a professional locksmith who can replace the chip quickly and at an affordable cost.

If your key fob does not function after being exposed to clean rain or tap water take the battery off. Clean the electronic component with a towel. If the key fob will not work, there's the possibility that it has an issue with the component and requires to be replaced.

Some people will go to their dealer in order to get a new Fiat fob. But, this can be costly. United Locksmith is the best place to go if you need your Fiat key fob repaired at a reasonable cost. We have the tools and knowledge necessary to repair your Fiat key fob in a timely and professional manner.

Faulty Receiver Module

Fiat key fobs send signals of up 50 feet away to the vehicle, which will unlock and close the doors (and start the vehicle if it has automatic transmissions). There are a variety of reasons why a fob could not function. This includes a dead battery, water damage, worn-out buttons, a receiver issue, signal interference or Workshop a malfunctioning chip.

If the fob was located in the pocket that has been subject to severe trauma (such as being dropped on the hard floor or washed in the washing machine) the fob might not be in a position to connect with the Body Control Module (BCM) of the car. The BCM is a security device that will only accept signals from genuine keys.

If this is the case, you will need to replace your fob. A professional locksmith is able to handle all aspects of the key replacement procedure and even program a new one for your 500. They can even offer a clone fob that works just like the original (and costs just one-third of the cost).